Create a one of kind creation with our white spangle transfer that is for sublimation.

Simply apply the spangle transfer peer the below instruction then position your sublimation transfer over it.

A downloadable DXF template has been included, make template 10.58 in x 6.85 in . You will have a slight bleed

Spangle Transfer Heat Press Instructions:

If spangle have moved out of place simply place in place with tweezers prior to pressing.

1. Remove white backing and place sticky side down on the shirt.

2. Press at 300F for 8 sec

3. Remove tape while hot ( I find holding the shirt down as I pull off the transfer is best)

Sublimation instructions:

1. Position on top of applied spangle transfer

2. Press at 385 F for 45 sec ( please note this may need to be adjusted depending on the paper and inks you are using)